Value Collection 95584 No.10 Self Drilling Screw 410 Ss

Product Description

The VALUE COLLECTION 95584 is a No. 10 self drilling screw with a hex washer head and hex drive, designed for fastening into light-gauge metal without pre-drilling. The 410 grade stainless steel construction provides corrosion resistance suitable for outdoor and moisture-prone environments. A No. 3 drill point bores through material and threads in a single operation, reducing installation time. The length under head measures 1.5 inches. This screw is installed by HVAC technicians, sheet metal workers, and plumbers in metal-to-metal and metal-to-substrate applications where a dependable self-starting fastener is required.

This screw is commonly used in HVAC ductwork assembly, metal roofing, equipment enclosures, and light structural sheet metal work. The hex washer head provides a broad bearing surface that resists pull-through, while the hex drive allows use with standard nut drivers and hex-bit drivers. The 410 stainless material grade suits applications where mild chemical exposure or outdoor conditions are a factor. The minimum order quantity is 50 pieces per order.

Key Features

• No. 3 drill point self-starts in light-gauge metal without a pilot hole
• Grade 410 stainless steel construction for corrosion resistance
• Hex washer head delivers wide bearing surface and reduces pull-through risk
• Hex drive compatible with standard nut drivers and impact hex-bit drivers
• 1.5 inch length under head suits common sheet metal and panel fastening depths
• Sold in multiples of 50 for job-site quantity efficiency

Compatibility

Designed as a standard No. 10 self drilling screw for light-gauge metal fastening applications in HVAC, plumbing, and general sheet metal fabrication and installation work.

Installation Notes

Installation is performed by sheet metal workers, HVAC technicians, or plumbers using a hex-bit driver or nut driver. Ensure the drill point is aligned perpendicular to the work surface before driving to prevent bit walking and fastener damage. Do not overdrive — hex washer head screws can strip the bearing surface or crack if torque is excessive. Follow applicable mechanical and building code requirements for fastener spacing and material gauge compatibility.