Value Collection 95566 No.14 Pan Head Self Drilling Screw 50pk

Product Description

The VALUE COLLECTION 95566 is a No. 14 pan head self drilling screw designed for fastening applications where pre-drilling is not practical or efficient. Featuring a Phillips drive and a No. 3 drill point, this screw bores through material and drives in a single step. Constructed from Grade 410 stainless steel, it offers solid corrosion resistance for use in demanding environments. The 1.5-inch length under head provides consistent bite depth across a range of material thicknesses. Sold in a pack of 50, this screw is suited for trade and production use where consistent, reliable fasteners are needed in volume.

This screw is commonly used in HVAC ductwork assembly, sheet metal fabrication, roofing, and general construction applications where self-tapping into metal or composite substrates is required. The pan head profile sits low and distributes load across the surface without requiring a countersunk hole. The Phillips drive is compatible with standard power drivers used by sheet metal workers, HVAC technicians, and general contractors. The Grade 410 stainless steel construction makes it appropriate for both interior and exterior applications where mild to moderate corrosion resistance is needed.

Key Features

• No. 3 drill point allows the screw to self-drill without a pilot hole
• Pan head profile provides flush, broad load distribution on flat surfaces
• Phillips drive compatible with standard power and hand drivers
• Grade 410 stainless steel construction for corrosion resistance
• 1.5-inch length under head suits a range of sheet metal and panel thicknesses
• Pack of 50 for production, service, and jobsite use

Compatibility

Designed as a general-purpose No. 14 self drilling screw for sheet metal, light structural, and HVAC ductwork fastening applications requiring a No. 3 drill point.

Installation Notes

Self drilling screws are installed by sheet metal workers, HVAC technicians, and general tradespeople using a standard Phillips-bit power driver set to appropriate torque or clutch setting to avoid overdriving. No pilot hole is required, but the material stack should not exceed the capacity of the No. 3 drill point for reliable penetration. Ensure substrate is secure and clamped before driving. Follow applicable codes and manufacturer guidelines for fastener spacing in structural or ductwork assemblies.