Value Collection 95512 8 Flat Head Phillips Self Drilling Screw

Product Description

The VALUE COLLECTION 95512 is a No. 8 self drilling screw with a flat head and Phillips drive, designed for fast, reliable fastening without a pre-drilled pilot hole. Built from Grade 410 stainless steel, this screw delivers solid corrosion resistance and mechanical strength in demanding environments. The No. 2 drill point cuts through sheet metal, light steel framing, and similar substrates cleanly. At 1-1/4 inches overall length, it suits thin-gauge applications where controlled penetration depth matters. Sold in a pack of 50, this fastener is suited for HVAC technicians, electricians, plumbers, and general trade professionals who need a dependable stainless steel self drilling fastener on the job.

This screw is commonly used in light commercial and residential construction and mechanical system installation. Typical applications include securing sheet metal duct sections, electrical enclosure panels, equipment housings, and light structural components where corrosion-resistant fasteners are required. The flat head profile sits flush with the mating surface, making it the right choice in applications where a low-profile finish is needed and surface protrusion is not acceptable.

Key Features

• No. 8 self drilling screw eliminates the need for a pre-drilled pilot hole
• Grade 410 stainless steel construction for corrosion resistance in wet or outdoor-exposed installations
• Flat head profile seats flush with the work surface
• Phillips drive compatible with standard No. 2 Phillips bits and power drivers
• No. 2 drill point rated for light-gauge sheet metal and similar substrates
• Pack of 50 for efficient stocking and job-site use

Compatibility

Designed as a general-purpose self drilling fastener for light-gauge sheet metal, HVAC ductwork, electrical enclosures, and similar trade applications requiring a No. 8 flat head Phillips drive screw.

Installation Notes

Self drilling screws are typically installed using a power drill or screw gun fitted with a No. 2 Phillips bit at controlled speed to allow the drill point to penetrate before the thread engages. Verify that the substrate gauge is within the rated capacity of a No. 2 drill point before installation. Wear appropriate PPE when driving fasteners into metal substrates. Refer to applicable building codes and manufacturer guidelines for fastener spacing and load requirements.