Value Collection -94697-1 Machine Screw 1/4-20 X 2.25 in 25pk

Product Description

The VALUE COLLECTION -94697-1 is a 1/4-20 x 2.25-inch pan head Phillips machine screw made from 18-8 stainless steel with a bright, uncoated finish. This fastener uses Unified National Coarse (UNC) threading and is sized with the length measured from under the head. The 18-8 stainless steel construction provides solid corrosion resistance for general-purpose applications. Sold in a pack of 25, these screws are suited for maintenance, repair, and assembly work across HVAC, plumbing, electrical, and mechanical trade environments where a standard inch-system fastener is required.

These machine screws are commonly used in light structural assembly, panel mounting, equipment enclosures, and general mechanical fastening tasks. The pan head profile provides a low-profile, wide-bearing surface that works well against flat material surfaces. The Phillips drive accommodates standard hand and power tools. They are appropriate for both indoor and outdoor use where moderate corrosion resistance is needed, and are packaged in quantities suitable for single-job or small-batch work.

Key Features

• 1/4-20 UNC thread for compatibility with standard inch-system nuts and tapped holes
• 2.25-inch length measured under the head
• Pan head profile with wide bearing surface and low profile
• Phillips drive for use with common hand tools and power drivers
• 18-8 stainless steel construction with bright, uncoated finish for corrosion resistance
• No washer — fastener only, clean installation profile

Compatibility

Designed as a standard inch-system machine screw for use with 1/4-20 threaded nuts, inserts, or tapped holes in metal, plastic, and similar materials across general mechanical and trade applications.

Installation Notes

Install using a Phillips screwdriver or power driver set to appropriate torque to avoid stripping the drive or over-tightening into softer materials. Confirm that the mating nut or tapped hole is also 1/4-20 UNC before installation. When used in electrical enclosures or panels, follow applicable NEC requirements for panel hardware. Stainless steel fasteners are susceptible to galling — apply anti-seize compound when threading into stainless or aluminum tapped holes.