Value Collection 94656 6-32 X 3/16 in Pan Head Screw 50pk

Product Description

The VALUE COLLECTION 94656 is a 6-32 x 3/16 inch pan head Phillips machine screw made from 18-8 stainless steel with a bright, uncoated finish. This UNC-threaded fastener is sold in a pack of 50 and is suited for light-duty mechanical assemblies where corrosion resistance and a low-profile head are required. The pan head geometry provides a wide bearing surface, and the Phillips drive works with standard #2 Phillips bits. At 3/16 inches measured under the head, this screw is a common choice in compact electrical enclosures, HVAC control panels, and similar trade applications.

This screw is used across residential and light commercial applications wherever a 6-32 UNC thread is called for. Typical install scenarios include securing control boards, terminal blocks, cover plates, and small brackets inside HVAC equipment, electrical panels, and plumbing control assemblies. The 18-8 stainless steel construction makes it appropriate for environments with moderate moisture exposure. The pack of 50 suits service stock or job-lot requirements.

Key Features

• 6-32 UNC thread, 3/16 inch length under head
• Pan head profile with Phillips drive for standard #2 bit
• 18-8 stainless steel construction for corrosion resistance
• Bright, uncoated finish — no added plating that can affect thread fit
• No washer — clean seating against panel surfaces
• Pack of 50 for service stock or single-job use

Compatibility

Designed as a general-purpose 6-32 UNC machine screw suitable for use in electrical enclosures, HVAC control panels, and light mechanical assemblies requiring a pan head Phillips fastener.

Installation Notes

Install with a standard #2 Phillips screwdriver or bit driver. Always power down electrical equipment and follow applicable NEC or local electrical code requirements before opening enclosures or control panels. Do not overtighten stainless steel fasteners into tapped steel or aluminum holes, as galling can occur — use appropriate thread lubricant if required by the application. Hand-start threads before applying driver torque to avoid cross-threading.