Value Collection 94066 10-24 X 0.5 in Round Head Phillips Screw 25pk

Product Description

The VALUE COLLECTION 94066 is a 10-24 UNC machine screw with a round head and Phillips drive, sold in a pack of 25. Manufactured from Grade 18-8 stainless steel with a bright, uncoated finish, this fastener resists corrosion in wet or chemically active environments. The 0.5-inch length is measured under the head. At 10-24 thread pitch, it suits a wide range of light mechanical assemblies encountered in HVAC, electrical, plumbing, and general equipment service work. The bright finish indicates no secondary coating, keeping thread tolerances tight and consistent.

These screws are used wherever a small, corrosion-resistant fastener is needed for panel attachment, bracket mounting, equipment access covers, and similar light-duty assembly tasks. The round head profile provides a low-profile bearing surface suitable for sheet metal panels and equipment enclosures. The Phillips drive is compatible with standard power and hand drivers commonly carried by HVAC technicians, electricians, and plumbers. Pack quantity of 25 suits both job-site restocking and small repair applications.

Key Features

• Grade 18-8 stainless steel construction for corrosion resistance in wet or outdoor-adjacent environments
• 10-24 UNC thread form for broad compatibility with standard tapped holes in equipment panels and brackets
• Round head profile distributes clamping load across the bearing surface
• Phillips drive accepts standard No. 2 driver bits — hand or power
• Bright, uncoated finish maintains precise thread tolerances
• Pack of 25 for shop stocking or multi-fastener repair tasks

Compatibility

Designed as a general-purpose replacement or stocking fastener for equipment panels, access covers, brackets, and light mechanical assemblies that call for a 10-24 UNC round-head Phillips machine screw.

Installation Notes

Installation is performed by the trade technician servicing the equipment. De-energize or lock out all electrical panels before fastening or removing screws on live enclosures in accordance with NFPA 70E and applicable NEC requirements. Use a properly sized No. 2 Phillips driver to avoid cam-out and head damage. Do not overtighten into thin sheet metal or plastic standoffs, as 18-8 stainless can gall when torqued against stainless-tapped holes — apply a small amount of anti-seize if thread galling is a concern.