Value Collection 92962 Pan Head Slotted Machine Screw 50pk

Product Description

The VALUE COLLECTION 92962 is a 10-24 x 0.75-inch pan head machine screw with a slotted drive, manufactured from 18-8 stainless steel with a bright, uncoated finish. Offered in a pack of 50, these screws are sized to UNC (Unified National Coarse) thread standards and measured length-under-head. The 18-8 stainless steel construction provides solid corrosion resistance for general-purpose fastening in HVAC, electrical, plumbing, and light mechanical applications. Installed by maintenance technicians, electricians, and plumbers in equipment panels, junction boxes, and enclosures where a non-magnetic, rust-resistant fastener is required.

These machine screws are suited for indoor and outdoor applications where mild-to-moderate corrosion resistance is needed without the cost of a higher-grade stainless alloy. The pan head profile seats flush against flat and thin sheet-metal surfaces without a washer. The slotted drive accommodates a standard flat-blade screwdriver, making them accessible with common hand tools. The 10-24 UNC thread pattern is one of the most widely used machine screw sizes in trade applications, fitting standard tapped holes in sheet metal, electrical enclosures, and equipment housings.

Key Features

• 10-24 UNC thread for compatibility with standard tapped holes in panels and enclosures
• Pan head profile provides a low-profile bearing surface without requiring a washer
• Slotted drive works with flat-blade screwdrivers and bit sets
• 18-8 stainless steel offers corrosion resistance for indoor and moderate outdoor environments
• Bright, uncoated finish — no plating to flake or interfere with grounding contact
• Pack of 50 for service stock and multi-fastener installations

Compatibility

Designed for use in any standard 10-24 tapped hole. Typical applications include electrical enclosures, junction boxes, equipment panels, and HVAC cabinet assemblies requiring a corrosion-resistant fastener.

Installation Notes

Installation requires a flat-blade screwdriver or matching slotted bit. Power down any electrical equipment and disconnect service before fastening hardware inside live panels or enclosures per NEC requirements. Do not overtighten into thin sheet metal or plastic standoffs, as 18-8 stainless fasteners can gall or seize if driven without lubrication into stainless-tapped holes — apply an anti-seize compound where metal-on-metal binding is a concern.