Value Collection 92629 Machine Screw 8-32 X 2 in Round Head Slotted

Product Description

The VALUE COLLECTION 92629 is a No. 8-32 x 2-inch round head slotted machine screw manufactured from 18-8 stainless steel with a bright, uncoated finish. The 8-32 designation indicates a Unified National Coarse (UNC) thread form with 32 threads per inch, suited for general fastening applications where corrosion resistance and moderate tensile strength are required. The round head profile provides a low-profile, finished appearance when installed flush against a surface. Length is measured under the head. This fastener is a standard choice for electricians, HVAC technicians, plumbers, and general trade professionals securing panels, enclosures, brackets, and equipment assemblies.

This screw is appropriate for light- to medium-duty fastening in residential and commercial trade applications. Common uses include securing electrical enclosure covers, control panel components, HVAC equipment brackets, and similar sheet metal or machined assemblies where a corrosion-resistant stainless fastener is preferred over zinc-plated steel. The slotted drive is compatible with standard flat-blade screwdrivers and is frequently found in legacy equipment and panel hardware applications. Minimum order quantity is 25 pieces per order.

Key Features

• 18-8 stainless steel construction provides corrosion resistance in humid or wet service environments
• 8-32 UNC thread form for compatibility with standard tapped holes and hex nuts in that thread class
• Round head profile delivers a clean, finished look on exposed fastener installations
• Slotted drive accepts standard flat-blade screwdrivers and manual drivers
• Bright uncoated finish — no plating buildup that could affect thread fit in close-tolerance tapped holes
• Length measured under head — 2 inches of full thread engagement available below the bearing surface

Compatibility

Designed as a standard 8-32 UNC machine screw for use in any application requiring a No. 8-32 round head slotted fastener in stainless steel with a 2-inch grip length.

Installation Notes

Installation requires a flat-blade screwdriver or slotted bit sized for a No. 8 screw head. Ensure the mating tapped hole or nut is 8-32 UNC thread form before driving. Do not overtighten stainless steel fasteners into tapped stainless components, as galling can occur — apply an anti-seize compound if both the screw and mating hardware are stainless. Follow applicable NEC or equipment manufacturer torque guidance where fastener tightening requirements are specified.