Value Collection 92588 1/4-20 X 3/4 in Flat Head Slotted Screw

Product Description

The VALUE COLLECTION 92588 is a 1/4-20 x 3/4 inch flat head slotted machine screw manufactured from 18-8 stainless steel with a bright, uncoated finish. It uses Unified National Coarse (UNC) threading at 1/4-20 and is measured by overall length at 3/4 inches. The flat head profile sits flush with the mating surface when fully driven, making it well suited for applications where a low-profile or countersunk finish is required. This screw is sold in a minimum order quantity of 25 pieces and is a standard fastener used by electricians, plumbers, HVAC technicians, and general maintenance trades.

This fastener is appropriate for light-duty mechanical assembly, panel mounting, enclosure work, and general equipment fastening in both residential and commercial settings. The 18-8 stainless steel construction provides good corrosion resistance, making it a common choice in environments with moisture exposure. A slotted drive accepts a standard flat-blade screwdriver, a tool found in virtually every trade kit. This screw is sold without a washer and is intended for use in pre-tapped holes or with a nut.

Key Features

• 1/4-20 UNC thread for broad compatibility with standard tapped holes and nuts
• 3/4 inch overall length with full-length threading under the head
• Flat head profile for flush or countersunk installations
• 18-8 stainless steel construction offers corrosion resistance without coating
• Bright, uncoated finish — no plating to crack, chip, or introduce galvanic concerns with stainless hardware
• Slotted drive accepts standard flat-blade screwdrivers

Compatibility

Designed as a standard 1/4-20 UNC machine screw for use in pre-tapped holes or with matching 1/4-20 nuts across a wide range of mechanical and electrical assembly applications.

Installation Notes

Power down or de-energize any equipment before installing fasteners in electrical enclosures or control panels. Use a properly sized flat-blade screwdriver to avoid damaging the slotted drive. Do not overtighten stainless steel fasteners, as galling can occur — apply a suitable anti-seize compound if repeated removal is expected. Installation should comply with applicable codes such as the NEC for electrical applications or relevant mechanical standards for structural use.