Value Collection 91755 Brass Flat Washer 100 Pack

Product Description

The VALUE COLLECTION 91755 is a size 14 screw standard flat washer made from brass with a plain finish. Designed for use in fastening assemblies where a broad bearing surface is needed under a bolt head or nut, this washer distributes load and reduces surface damage on the mating material. It measures 0.26 inches inner diameter, 11/16 inches outer diameter, and 0.051 inches thick. Supplied in a 100-piece package, it suits plumbing, HVAC, electrical, and general mechanical applications where a corrosion-resistant brass washer is required.

This flat washer is suited for residential and light commercial installations involving size 14 screws. Common applications include pipe flange assemblies, fixture mounting, and equipment panels where brass is preferred for its corrosion resistance and conductivity properties. The inch-system dimensions make it a standard fit for North American trade work. Plumbers, HVAC technicians, and electricians will find this washer useful as a general-purpose fastener component across a wide range of service and installation tasks.

Key Features

• Brass construction provides corrosion resistance and moderate conductivity
• Plain finish with no coating — suitable for direct contact with brass or copper fasteners
• 0.26 inches ID sized for size 14 screws
• 0.051 inches thick for consistent load distribution
• Packaged in 100-piece quantities for shop stock or job-site use
• Inch-system dimensions for compatibility with standard North American fastener hardware

Compatibility

Designed as a standard flat washer for use with size 14 screws in inch-system fastener assemblies across plumbing, HVAC, electrical, and general mechanical applications.

Installation Notes

Flat washers are installed by plumbers, HVAC technicians, and electricians as part of standard fastener assemblies. Always ensure the washer ID matches the screw or bolt diameter before installation to prevent misalignment or loosening under load. De-energize or shut off any system before disassembling fastened components. Follow applicable codes such as NEC or IPC for fastener and material requirements in specific trade applications.