Value Collection 81923906 Sae Flat Washer 3/8 in Steel Zinc

Product Description

The VALUE COLLECTION 81923906 is a Grade 2 steel SAE flat washer designed for use with 3/8 inch screws. It features a zinc-plated finish for corrosion resistance in standard indoor and light-duty applications. With an inside diameter of 0.401 inches, an outside diameter of 0.822 inches, and a thickness of 0.08 inches, this washer conforms to SAE dimensional standards. Each package contains 50 washers. This part is used by electricians, plumbers, HVAC technicians, and general contractors who need a reliable, standardized flat washer for fastening assemblies across a wide range of trade applications.

SAE flat washers are used where a larger bearing surface is needed to distribute load and prevent fastener pull-through or surface damage. This washer is suited for light structural, mechanical, and equipment-mounting applications in both residential and commercial settings. The zinc plating provides a basic level of corrosion resistance appropriate for dry or mildly humid environments. Sold in a 50-piece package, this washer is a practical addition to any service van or job-site hardware supply.

Key Features

• SAE flat washer profile distributes load across a wider bearing surface
• Grade 2 steel construction provides adequate strength for standard fastening tasks
• Zinc-plated finish offers basic corrosion resistance for indoor and light-duty use
• Inside diameter of 0.401 inches fits 3/8 inch screw shafts
• Outside diameter of 0.822 inches and thickness of 0.08 inches meet SAE dimensional standards
• 50-piece package quantity supports bulk job-site use

Compatibility

Designed for use with 3/8 inch fasteners in standard SAE inch-measurement applications across mechanical, electrical, and plumbing assemblies.

Installation Notes

Install with the appropriate 3/8 inch bolt or screw, ensuring the washer seats flat against the mating surface before torquing the fastener. Always de-energize electrical equipment and shut off relevant systems before beginning any fastener work in live panels or pressurized assemblies. Use hand tools appropriate to the fastener drive type. Zinc-plated washers are not recommended for outdoor or high-moisture environments where stainless or hot-dip galvanized hardware is required.