Value Collection 808-012 Pvc 90 Elbow 1-1/4 in Sch 80 Fipt

Product Description

The VALUE COLLECTION 808-012 is a Schedule 80 PVC 90-degree elbow fitting designed for threaded pipe assemblies in pressurized fluid systems. Sized at 1-1/4 inches with female iron pipe thread (FIPT) connections on both ends, this fitting accepts male-threaded pipe or fittings for a secure, sealed joint. Schedule 80 wall thickness provides greater pressure tolerance than Schedule 40, making it appropriate for higher-demand applications. Plumbers and pipefitters install this fitting where a 90-degree directional change is required in a threaded PVC run. It weighs approximately 0.79 pounds.

This elbow is suited for residential and light commercial plumbing, irrigation, and industrial process piping where PVC is an approved material. The FIPT x FIPT configuration is commonly used when connecting to male-threaded valves, pumps, tanks, or other equipment. It is appropriate for cold and moderate-temperature water service, chemical handling lines, and non-combustible fluid distribution systems where Schedule 80 PVC is permitted by the applicable code.

Key Features

• Schedule 80 PVC construction for increased pressure rating versus Schedule 40
• 1-1/4 inch fitting size for standard pipe sizing in that nominal range
• FIPT x FIPT end connections accept male-threaded pipe and fittings on both ends
• 90-degree sweep for making right-angle directional changes in threaded pipe runs
• Lightweight at 0.79 pounds for easy handling during assembly

Compatibility

Designed as an OEM-style replacement or new-installation fitting compatible with 1-1/4 inch Schedule 80 PVC threaded pipe systems using standard NPT male threads.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the International Plumbing Code (IPC) or applicable local code. Depressurize and drain the system completely before removing any existing fittings or threading this elbow into place. Apply a code-approved thread sealant or PTFE tape to the male threads before assembly. Do not overtighten threaded PVC fittings, as this can crack the fitting body.