Value Collection 662090PR M4x0.7 Pan Head Phillips Screw 80mm

Product Description

The VALUE COLLECTION 662090PR is a metric pan head machine screw designed for general mechanical assembly applications. It features a Phillips drive and an M4x0.7 thread with an 80 mm length measured under the head. Manufactured from Grade 4.8 carbon steel with a zinc finish, this screw delivers reliable corrosion resistance and meets DIN 7985 and ISO 7045 dimensional standards. It is a standard fastener installed by maintenance technicians, millwrights, machinists, and assembly workers across a wide range of light to medium-duty applications where a low-profile pan head and Phillips drive are specified.

This screw is suited for use in residential and commercial equipment assembly, machine frames, electrical enclosures, control panels, and general fabrication. The M4x0.7 thread size and 80 mm shank length make it a common selection for through-bolt applications in sheet metal and light structural assemblies. The zinc coating provides a degree of protection in mildly corrosive or humid environments. These screws are sold in a minimum order quantity of 100 pieces per package, making them appropriate for production-level or service-shop inventory.

Key Features

• M4x0.7 metric thread for consistent, standardized fit in tapped holes and nuts
• Pan head profile provides a low-profile bearing surface without sharp edges
• Phillips drive compatible with standard power and hand tools
• Grade 4.8 steel construction balances hardness and ductility for general fastening
• Zinc finish adds corrosion resistance in typical indoor and light-outdoor environments
• Conforms to DIN 7985 and ISO 7045 for dimensional and mechanical compliance

Compatibility

Designed as a standard metric replacement or production fastener for any application calling for an M4x0.7 pan head Phillips machine screw conforming to DIN 7985 or ISO 7045 specifications.

Installation Notes

Install with a hand screwdriver or power driver fitted with the appropriate Phillips bit to avoid cam-out and head damage. Verify that the mating tapped hole or nut is the correct M4x0.7 metric thread pitch before driving. Do not exceed the torque capacity appropriate for Grade 4.8 fasteners in the mating material. Ensure the screw is fully seated and that the zinc finish is intact to maintain corrosion resistance after installation.