Value Collection 587-060S160BC Black Pipe Nipple Sch 160

Product Description

The VALUE COLLECTION 587-060S160BC is a black steel pipe nipple used to connect threaded pipe sections in high-pressure plumbing, industrial, and mechanical piping systems. It measures 1.5 inches in nominal diameter and 6 inches in length, manufactured to Schedule 160 wall thickness for service in demanding pressure applications. The black finish is a standard mill coating suitable for gas lines, steam systems, and other non-corrosive fluid transport applications. Licensed plumbers and pipefitters install these nipples in commercial and industrial settings where heavy-wall pipe is specified by system design or code.

This nipple is suited for use in residential gas distribution, commercial steam and hydronic heating systems, and industrial fluid transfer lines where Schedule 160 heavy-wall construction is required. The threaded ends allow direct connection to standard NPT fittings, valves, and pipe couplings. It is a common component in close-coupled connections where a short, rigid threaded piece is needed between two fittings or components.

Key Features

• Schedule 160 heavy-wall construction for high-pressure service
• 1.5-inch nominal pipe size with NPT-compatible threaded ends
• 6-inch overall length suitable for close-coupled or extended nipple applications
• Black mill finish for use in gas, steam, and non-corrosive fluid systems
• Sold individually for single-unit replacement or repair work

Compatibility

Designed as a standard NPT-threaded replacement nipple compatible with Schedule 160 black steel pipe systems using 1.5-inch nominal pipe size fittings, valves, and couplings.

Installation Notes

Installation of black steel pipe nipples should be performed by a licensed plumber or pipefitter in accordance with applicable codes such as the International Plumbing Code or International Fuel Gas Code. Shut off and depressurize the system completely before removing or installing any threaded pipe component. Apply an approved pipe thread sealant or PTFE tape to the male threads before making up the joint. Do not over-tighten threaded connections, as this can crack fittings or damage thread integrity.