Value Collection 57531261 Galvanized Duct 90 Stack Boot 6 in

Product Description

The VALUE COLLECTION 57531261 is a galvanized steel 90-degree stack boot designed for residential and light commercial duct systems. It transitions from round duct to a floor or wall register opening, redirecting airflow at a 90-degree angle through a rectangular outlet. The boot features a 6-inch inside diameter round inlet and a 3-1/4-inch by 12-inch rectangular outlet face, making it a standard size for supply-air floor boot applications. Fabricated from galvanized steel at standard gauge, it resists corrosion in typical HVAC environments. HVAC installers and sheet metal contractors handle this fitting during new construction and system modification work.

This stack boot is suited for forced-air supply duct systems where a vertical duct stack feeds a floor or baseboard register. The 6-inch ID inlet connects directly to 6-inch round duct or collar takeoffs from a trunk line. The 3-1/4-inch by 12-inch rectangular outlet aligns with standard floor register openings of the same face size. It is commonly installed in residential construction, light commercial tenant improvements, and duct retrofit projects where floor-mounted registers are required.

Key Features

• 90-degree turn geometry routes airflow from vertical duct stack to horizontal floor register plane
• 6-inch inside diameter round inlet fits standard 6-inch round duct and snap-lock collars
• 3-1/4-inch by 12-inch rectangular outlet matches standard floor register and boot dimensions
• Galvanized steel construction provides corrosion resistance for long-term duct system use
• Standard gauge fabrication meets typical residential and light commercial duct installation requirements

Compatibility

Designed as an OEM-style replacement and new-installation fitting compatible with standard 6-inch round residential and light commercial forced-air supply duct systems using 3-1/4-inch by 12-inch floor registers.

Installation Notes

Installation is typically performed by a licensed HVAC technician or sheet metal contractor. The air handling system should be powered down and the blower confirmed off before cutting into any existing ductwork. Sheet metal screws and UL 181-listed duct tape or mastic sealant are used to secure and seal the boot to the round duct inlet and the subfloor register opening. Local mechanical codes based on the IMC or SMACNA standards govern duct installation practices and should be consulted before work begins.