Value Collection 4CB3/4 Pipe End Cap 3/4 in 304 Ss Fnpt

Product Description

The VALUE COLLECTION 4CB3/4 is a threaded pipe end cap designed to close off the open end of a 3/4-inch pipe in fluid and gas piping systems. Machined from 304 stainless steel, it connects via a female NPT (FNPT) thread and carries a pressure rating of 150 psi. This cap provides a clean, pressure-rated termination point and resists corrosion in a wide range of service environments. Plumbers, pipefitters, and mechanical contractors use end caps like this to cap unused branch lines, test pipe assemblies, or permanently seal off piping runs during system modifications or new construction.

This fitting is suited for use in residential and commercial plumbing, industrial process piping, and mechanical systems where a 3/4-inch threaded termination is required. The 304 stainless steel construction makes it appropriate for water, air, and many mild chemical service applications. It is installed wherever a threaded pipe end needs to be permanently or temporarily closed, including branch takeoffs, test ports, and retrofit piping work.

Key Features

• 304 stainless steel construction for corrosion resistance in wet and chemical-adjacent environments
• FNPT connection threads directly onto standard 3/4-inch male NPT pipe ends
• 150 psi pressure rating suitable for typical low-pressure plumbing and process piping applications
• Compact end cap profile minimizes clearance requirements at pipe terminations
• Single-piece threaded design requires no special tooling beyond a pipe wrench or strap wrench

Compatibility

Designed as a standard FNPT threaded end cap for use with 3/4-inch male NPT pipe ends in 150 psi-rated piping systems.

Installation Notes

Installation is performed by licensed plumbers or pipefitters in accordance with applicable IPC and local mechanical codes. Shut off and depressurize the piping system fully before installing or removing threaded fittings. Apply an approved pipe thread sealant or PTFE tape to the male NPT threads before threading on the cap. Do not overtighten; use a pipe wrench for a firm, leak-free connection and confirm with a pressure test before returning the system to service.