Value Collection 498-015 Pvc Pipe Union 1-1/2 in Sch 40

Product Description

The VALUE COLLECTION 498-015 is a Schedule 40 PVC pipe union with an EPDM O-ring seal, designed for use in low-pressure plumbing and fluid-handling systems. At 1-1/2 inches in size with female iron pipe thread (FIPT) connections on both ends, this union allows sections of pipe to be joined and separated without cutting. The EPDM O-ring provides a reliable, chemically resistant seal at the union joint. Weighing 0.45 pounds, the fitting is lightweight and easy to handle during installation. Plumbers and pipefitters working on residential and light commercial systems are the primary installers.

This union is suited for Schedule 40 PVC piping systems used in cold and ambient-temperature water supply, irrigation, pool and spa plumbing, and general fluid distribution lines. The FIPT x FIPT end connections accept standard threaded male pipe fittings on both sides, making it compatible with a wide range of threaded PVC and transitional adapters. It is a practical choice for service points where future pipe disconnection is anticipated, such as equipment isolation or pump connections.

Key Features

• Schedule 40 PVC construction for standard-duty plumbing service
• EPDM O-ring provides a leak-resistant seal at the union joint
• 1-1/2 inch FIPT x FIPT end connections for threaded pipe assembly
• Lightweight at 0.45 pounds for easy single-person handling
• Allows pipe disassembly without cutting, simplifying future service

Compatibility

Designed as a standard replacement or new-installation union for Schedule 40 PVC threaded piping systems using 1-1/2 inch female iron pipe thread connections.

Installation Notes

Installation is typically performed by licensed plumbers in accordance with applicable local plumbing codes and IPC guidelines. Depressurize and drain the line before removing or installing the union. Apply thread sealant tape or paste to the male threads being engaged, and tighten hand-firm before using a strap wrench to avoid overtightening and cracking the PVC body. Do not use petroleum-based solvents or lubricants on EPDM O-ring components.