Value Collection 48260 Water Heater Supply Line 18 in

Product Description

The VALUE COLLECTION 48260 is an 18-inch stainless steel water heater supply line designed to connect a water heater to the hot or cold water supply in residential plumbing installations. It features a 3/4-inch compression inlet and a 3/4-inch MIP (male iron pipe) threaded outlet, providing a secure, leak-resistant connection at both ends. The corrugated stainless steel construction resists corrosion and handles demanding operating conditions, with a maximum working pressure rating of 2,500 psi. This supply line is installed by licensed plumbers during water heater replacement or new installation.

This supply line is suited for residential water heater applications where a durable, code-appropriate flexible connector is required. The 18-inch length accommodates standard rough-in spacing between the water heater tank nipples and the building supply lines. It is compatible with both tank-style and tankless water heater installations that use 3/4-inch compression and 3/4-inch MIP connection points. The rated minimum working temperature of 15 degrees F and maximum inlet temperature of 158 degrees F align with typical domestic hot water service conditions.

Key Features

• Corrugated stainless steel construction resists corrosion and physical damage
• 3/4-inch compression inlet for tool-assisted, leak-resistant connection to the supply stub-out
• 3/4-inch MIP outlet threads directly onto standard water heater nipples
• 2,500 psi maximum working pressure rating for margin well beyond residential service demands
• 18-inch length fits standard water heater rough-in clearances
• Maximum inlet temperature of 158 degrees F rated for hot water supply service

Compatibility

Designed as an OEM-style replacement supply line for residential water heaters requiring a 3/4-inch compression inlet and 3/4-inch MIP outlet connection.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the International Plumbing Code (IPC) and applicable local codes. Shut off the cold water supply and drain pressure from the lines before disconnecting any existing connectors. Hand-tighten the compression fitting first, then use an appropriately sized wrench to seat the connection — do not overtighten. Inspect both connections for leaks after restoring water pressure before returning the water heater to service.