Value Collection 447-030 Pvc End Cap 3 in Sch 40 Slip

Product Description

The VALUE COLLECTION 447-030 is a 3-inch Schedule 40 PVC pipe end cap designed to terminate open pipe ends in plumbing, irrigation, and fluid-handling systems. The slip connection style seats directly over the outside of a pipe for solvent-weld installation, creating a permanent, pressure-rated closure. Fabricated from PVC, this cap resists corrosion and common chemicals encountered in residential and light commercial piping work. At 0.9 pounds, it is lightweight enough for single-handed handling during overhead or confined-space installations. Licensed plumbers and pipefitters are the typical installers for this type of fitting.

This end cap fits standard 3-inch Schedule 40 PVC pipe and is suited for cold and ambient-temperature water supply, drain-waste-vent (DWV) systems, irrigation laterals, and industrial process lines where PVC is code-approved. It is commonly used to cap off unused branch outlets, seal pipe stubs during rough-in inspections, or permanently close lines that have been decommissioned. The slip end connection requires solvent cement for a leak-free joint, making it a straightforward, one-step termination fitting.

Key Features

• Schedule 40 wall thickness for use in standard-pressure PVC piping systems
• Slip connection accepts 3-inch PVC pipe OD for solvent-weld installation
• PVC construction provides corrosion resistance and chemical compatibility with common water and irrigation fluids
• Lightweight at 0.9 pounds for easy handling in tight or overhead installations
• Single-piece molded construction with no seams or mechanical fasteners

Compatibility

Designed as an OEM-style replacement fitting compatible with standard 3-inch Schedule 40 PVC piping systems using slip-style solvent-weld connections.

Installation Notes

Installation is performed by a licensed plumber or qualified pipefitter in accordance with applicable IPC or local plumbing code requirements. Shut off and depressurize the line completely before cutting or capping. Clean and dry both the pipe end and the fitting socket before applying PVC primer and solvent cement per the cement manufacturer instructions. Allow the joint to cure fully before restoring pressure to the line.