Value Collection 437-212 Pvc Pipe Bushing 1.5x1.25in Sch 40

Product Description

The VALUE COLLECTION 437-212 is a Schedule 40 PVC pipe bushing designed to reduce a 1-1/2-inch pipe or fitting to a 1-1/4-inch connection. The spigot end inserts into a socket fitting on the larger side, while the slip end accepts a 1-1/4-inch pipe or fitting on the smaller side. PVC construction makes this bushing resistant to corrosion, most chemicals, and moisture. It is a standard plumbing fitting used in low-pressure drain, waste, and vent (DWV) or cold-water supply systems. Plumbers and pipefitters install these fittings when transitioning between two common pipe sizes within a PVC system.

This bushing is suited for residential and light commercial plumbing applications where a PVC Schedule 40 system requires a size reduction. Typical install scenarios include branch line transitions, fixture rough-ins, and equipment connections where a 1-1/2-inch line steps down to a 1-1/4-inch line. The spigot x slip end configuration integrates directly into standard Schedule 40 socket fittings and pipe without adapters.

Key Features

• Schedule 40 PVC construction for standard-duty pressure and DWV service
• Spigot x slip end connection for tool-free, solvent-weld assembly
• Reduces 1-1/2-inch to 1-1/4-inch in a single fitting
• Corrosion-resistant PVC material suitable for most water and chemical drain applications
• Compact bushing profile minimizes added length in tight installations

Compatibility

Designed as an OEM-style replacement or new-installation fitting compatible with Schedule 40 PVC piping systems using 1-1/2-inch and 1-1/4-inch nominal pipe sizes and standard spigot and slip socket fittings.

Installation Notes

Installation is performed by licensed plumbers or qualified pipefitters following applicable IPC or local plumbing code requirements. Shut off the water supply and drain the line before cutting into any existing system. Clean and dry all mating surfaces, apply PVC primer and solvent cement per manufacturer instructions, and allow adequate cure time before restoring flow. Do not use this fitting on systems with operating temperatures or pressures outside the Schedule 40 PVC rating.