Value Collection 437-211 Pvc Pipe Bushing 1.5x1 in Sch 40

Product Description

The VALUE COLLECTION 437-211 is a Schedule 40 PVC pipe bushing used to reduce a 1-1/2-inch pipe or fitting down to a 1-inch line. The spigot end inserts into a socket-type fitting on the larger side, while the slip end accepts a 1-inch pipe or fitting on the smaller side. PVC construction resists corrosion and common chemicals found in plumbing and irrigation systems. This bushing is a standard component in residential and light commercial pipe runs where a reduction in line size is required without threading. Plumbers and pipefitters install this type of fitting as part of drain, waste, vent, and supply configurations.

This bushing fits into Schedule 40 PVC piping systems commonly found in residential plumbing, irrigation, and low-pressure water distribution. The spigot x slip end connection type makes it compatible with standard socket-weld PVC assembly using solvent cement. It is suited for above-ground and below-grade installations where PVC is an approved material under local codes. The fitting is sold individually, with a minimum order quantity of 5 units.

Key Features

• Reduces 1-1/2-inch pipe to 1-inch line in a single fitting
• Schedule 40 PVC construction for standard-pressure plumbing applications
• Spigot x slip end connections allow solvent-cement assembly
• Corrosion-resistant PVC material suits water, irrigation, and drain applications
• Lightweight at 0.4 pounds per unit

Compatibility

Designed as an OEM-style replacement or new-installation component for Schedule 40 PVC piping systems using 1-1/2-inch to 1-inch reduction fittings with spigot x slip connections.

Installation Notes

Installation is performed by a licensed plumber or qualified pipefitter following applicable IPC or local plumbing code requirements. Shut off water supply and depressurize the line before cutting into any existing pipe run. Solvent-cement both the spigot end into the receiving socket and the slip socket onto the incoming pipe per the PVC cement manufacturer's cure time instructions. Do not apply heat or use petroleum-based lubricants on PVC fittings.