Value Collection 417-020 Pvc 45 Elbow 2 in Sch 40

Product Description

The VALUE COLLECTION 417-020 is a 2-inch Schedule 40 PVC 45-degree elbow fitting used to redirect flow in low-pressure drain, waste, vent, and cold-water supply piping systems. Manufactured from rigid PVC, this fitting accepts slip connections on both ends, allowing solvent-cement bonding to standard Schedule 40 PVC pipe. It is a common component in residential and light commercial plumbing rough-in work, irrigation systems, and conduit applications. Plumbers and pipefitters install this fitting wherever a 45-degree directional change is needed without the abrupt pressure drop associated with a 90-degree turn.

This elbow is suited for residential and commercial drain, waste, and vent systems as well as cold-water supply and irrigation lines that call for Schedule 40 PVC. It is a direct-fit component for any application requiring a 2-inch, slip-connection 45-degree elbow in Schedule 40 PVC piping. The slip x slip end configuration is compatible with standard 2-inch Schedule 40 PVC pipe and is cemented using an appropriate PVC primer and solvent cement per local plumbing code requirements.

Key Features

• 45-degree elbow geometry for gradual directional changes that reduce flow turbulence
• Schedule 40 PVC construction for compatibility with standard DWV and cold-water supply systems
• Slip x Slip end connections accept solvent-cement bonding to Schedule 40 PVC pipe
• 2-inch fitting size fits standard 2-inch Schedule 40 PVC pipe
• Lightweight PVC material resists corrosion and chemical degradation in typical plumbing environments

Compatibility

Designed as a standard replacement or new-installation fitting for 2-inch Schedule 40 PVC piping systems using slip-connect, solvent-welded joints.

Installation Notes

Installation is performed by licensed plumbers or qualified pipefitters following applicable IPC or local plumbing code requirements. Shut off the water supply and depressurize the line before cutting into an existing system. Clean and deburr pipe ends, apply PVC primer, then apply solvent cement to both the pipe end and the fitting socket before joining. Allow adequate cure time per the cement manufacturer instructions before pressurizing the system.