Value Collection 409-015 Pvc 90 Street Elbow 1-1/2 in Sch 40

Product Description

The VALUE COLLECTION 409-015 is a Schedule 40 PVC 90-degree street elbow designed for use in residential and commercial pressure piping systems. Sized at 1-1/2 inches, it features a spigot (male) inlet and a slip (socket) outlet, allowing it to connect directly into a fitting socket on one end without requiring an additional coupling. This configuration is a common time-saver during layout and repair work. Licensed plumbers and pipefitters install this fitting in cold and hot water supply lines, drain-waste-vent systems, and irrigation piping where PVC Schedule 40 material meets code requirements.

This elbow is suited for standard-pressure residential and light commercial plumbing applications. The 1-1/2-inch size is frequently found in branch lines, fixture drain connections, and pump discharge runs. The spigot-by-slip end configuration makes it particularly useful when transitioning from a standard slip fitting to a new run without adding extra pipe length. It is compatible with standard Schedule 40 PVC piping and fittings following ASTM dimensional standards.

Key Features

• 90-degree street elbow geometry — directional change without an additional coupling
• Schedule 40 wall thickness rated for standard residential and commercial service pressures
• Spigot x Slip end connections for direct fitting-to-fitting installation
• PVC material is corrosion-resistant and compatible with common solvent-weld cements
• 1-1/2-inch fitting size fits standard Schedule 40 PVC pipe and fittings

Compatibility

Designed as an OEM-style replacement or new-installation fitting for standard Schedule 40 PVC piping systems using 1-1/2-inch pipe diameter.

Installation Notes

Installation is performed by licensed plumbers or qualified pipefitters following applicable IPC or local plumbing code requirements. Shut off the water supply and depressurize the line before cutting into an existing system. Clean and dry all mating surfaces, apply PVC primer and solvent-weld cement per the cement manufacturer's instructions, and allow full cure time before pressurizing. Do not use this fitting with CPVC or ABS solvent cements, as they are not compatible with standard PVC.