Value Collection 407-1541 Fully Threaded Stud 10-24 3/4 in

Product Description

The VALUE COLLECTION 407-1541 is a fully threaded stud with a 10-24 Unified National Coarse thread form and a 0.75 inch overall length. The stud is manufactured from carbon steel to material grade 5.8 with an uncoated plain finish, providing a minimum tensile strength of 60,000 psi. Because the stud is fully threaded from end to end, it offers maximum thread engagement across the entire shaft length. It is a standard fastener used by electricians, HVAC technicians, plumbers, and general mechanical contractors wherever a double-ended threaded connection point is required in light-duty steel assemblies.

This stud is suited for residential and light commercial mechanical and electrical applications where a 10-24 threaded connection is specified. Typical install scenarios include panel mounting, equipment chassis assembly, conduit hanger fabrication, and control-box component attachment. The 0.75 inch OAL makes it appropriate for thin-material stacking applications where a longer fastener would bottom out or protrude excessively. Sold individually with a minimum order quantity of 25 pieces.

Key Features

• Fully threaded along the entire 0.75 inch shaft for maximum thread engagement
• 10-24 UNC thread form compatible with standard 10-24 nuts and tapped holes
• Carbon steel construction with material grade 5.8 rating
• Minimum tensile strength of 60,000 psi for reliable light-duty fastening
• Uncoated plain finish suitable for dry or protected indoor environments
• No flat ground on shank, allowing installation with standard locking nuts on both ends

Compatibility

Designed as a standard 10-24 fully threaded stud for use in any application requiring a 10-24 UNC thread form with a 0.75 inch overall length and carbon steel construction.

Installation Notes

Installation requires a 10-24 compatible nut driver, hex nut, or threaded insert on each engaged end. Apply appropriate thread-locking compound or hardware if vibration is a concern in the application. Ensure mating tapped holes or nuts are clean and free of debris before installation. Follow applicable mechanical and electrical codes for fastener selection in structural or load-bearing assemblies.