Value Collection 407-1047 Fully Threaded Stud 10-32 1-1/2 in

Product Description

The VALUE COLLECTION 407-1047 is a fully threaded stud with a 10-32 UNF thread form and an overall length of 1.5 inches. The stud is fully threaded from end to end, meaning the thread length equals the overall length with no plain shank section. Constructed from 18-8 stainless steel with an uncoated finish, it provides reliable corrosion resistance in wet, humid, or mildly caustic environments. This fastener is suited for light-duty mechanical assemblies, panel mounting, and equipment fabrication work common in HVAC, electrical, and plumbing trade applications. Minimum tensile strength is rated at 75,000 psi.

The 407-1047 is used where a permanent or semi-permanent threaded post is needed without a bolt head. Typical applications include mounting small components, securing terminal blocks, attaching brackets, and similar light fastening tasks in residential and commercial trade equipment. The 10-32 thread size is standard in electrical enclosures, control panels, and sheet metal assemblies. The stainless steel construction makes it appropriate for outdoor or moisture-prone installations where carbon steel hardware would corrode prematurely.

Key Features

• Fully threaded end-to-end — no plain shank, maximum thread engagement across the full 1.5-inch length
• 18-8 stainless steel construction — corrosion resistance suitable for damp or outdoor environments
• 10-32 UNF thread — standard pitch for electrical panels, control enclosures, and light equipment assemblies
• Uncoated plain finish — no plating to chip, flake, or interfere with electrical grounding contact
• Minimum tensile strength of 75,000 psi for reliable hold in light-to-medium load applications

Compatibility

Designed as a standard 10-32 fully threaded stud for use in any application requiring a 10-32 UNF threaded fastener with a 1.5-inch overall length.

Installation Notes

Installation is typically performed by electricians, HVAC technicians, or mechanical contractors during panel assembly or equipment fabrication. Power down and de-energize any electrical enclosure before installing or removing studs near live components. Use the appropriate hex nut driver or nut to seat the stud without cross-threading the mating component. Avoid over-torquing into soft or thin sheet metal to prevent thread stripping.