Value Collection 406-101 Pvc 90 Elbow 3/4x1/2 Sch 40

Product Description

The VALUE COLLECTION 406-101 is a Schedule 40 PVC 90-degree elbow fitting designed to change flow direction in low-pressure piping systems. It accepts slip connections on both ends, allowing solvent-welded joints with standard PVC pipe. The fitting transitions from a 3/4-inch inlet to a 1/2-inch outlet, making it suited for reducer applications at branch points or terminal runs. Weighing 0.45 pounds, it is lightweight and easy to handle in confined spaces. Plumbers and pipefitters install this type of fitting in residential and light commercial plumbing, irrigation, and drain systems where a clean 90-degree turn is required.

This elbow is used in Schedule 40 PVC piping systems for cold and ambient-temperature water distribution, irrigation laterals, and general-purpose fluid conveyance. The 3/4 x 1/2-inch reducing configuration handles branch runs where a main 3/4-inch line steps down to a 1/2-inch feed. It is a common component in residential supply lines, garden irrigation manifolds, and pool or spa plumbing where directional changes and size reductions occur at the same fitting location.

Key Features

• Schedule 40 wall thickness rated for standard residential and light commercial service pressures
• Slip x Slip end connections accept solvent-cement bonding for a permanent, leak-free joint
• Reducing configuration transitions 3/4-inch pipe to 1/2-inch pipe in a single fitting
• PVC construction resists corrosion, scale buildup, and most common household chemicals
• Lightweight at 0.45 pounds for easy handling during overhead or confined-space installation

Compatibility

Designed as an OEM-style replacement or new-installation fitting compatible with Schedule 40 PVC pipe systems using 3/4-inch and 1/2-inch nominal pipe sizes with slip-style solvent-weld connections.

Installation Notes

Installation is performed by licensed plumbers or qualified pipefitters following applicable IPC and local plumbing code requirements. Shut off water supply and depressurize the line before cutting into an existing system. Clean and deburr pipe ends, apply PVC primer, then solvent cement per the cement manufacturer's instructions before seating the pipe into the slip socket. Allow full cure time before restoring pressure to the line.