Value Collection 38022 10-32 X 1.5 in Round Head Phillips Screw

Product Description

The VALUE COLLECTION 38022 is a 10-32 x 1.5-inch round head Phillips machine screw intended for general-purpose fastening in trade and light industrial applications. Manufactured from Grade 2 steel with a zinc-plated finish, this fastener provides basic corrosion resistance suitable for indoor and protected environments. The 10-32 thread designation indicates a Unified National Fine (UNF) thread form, which offers greater thread engagement per inch compared to coarse-thread fasteners of the same diameter. Length is measured under the head. This screw is sold in a minimum order quantity of 50 pieces per order.

This fastener is used wherever a 10-32 UNF machine screw is specified — common in electrical enclosures, control panels, HVAC equipment cabinets, switchgear, and light mechanical assemblies. The round head profile provides a low-profile, finished appearance and distributes clamping load across a wider bearing surface. The Phillips drive is compatible with standard and power-drive tools. No washer is included or integrated into the fastener design.

Key Features

• 10-32 UNF thread form for fine-thread engagement and secure hold in tapped holes
• 1.5-inch length measured under the head for accurate stack-up calculations
• Round head profile with Phillips drive for compatibility with standard screwdrivers and power drivers
• Grade 2 steel construction — suitable for general-duty, non-structural fastening
• Zinc-plated finish for basic corrosion protection in dry or indoor environments
• No integrated washer — use with separate washers if load distribution requires it

Compatibility

Designed as a standard 10-32 UNF machine screw for use in any tapped hole or threaded insert specifying a 10-32 thread, round head, and Phillips drive in inch-measurement applications.

Installation Notes

This screw is installed by electricians, HVAC technicians, and mechanical trades using a Phillips screwdriver or power driver sized for a No. 2 Phillips bit. Always de-energize electrical equipment before accessing internal fastening points inside panels or enclosures, following NFPA 70E lockout/tagout procedures. Do not overtighten into thin sheet metal or plastic standoffs, as Grade 2 steel fasteners in fine threads can strip the mating material before reaching fastener failure. Inspect threads for damage before installation if reusing tapped holes.