Value Collection 38001 6-32 X 3/8 in Round Head Phillips Screw

Product Description

The VALUE COLLECTION 38001 is a 6-32 x 3/8 inch round head Phillips machine screw made from Grade 2 steel with a zinc-plated finish. It features Unified National Coarse (UNC) threading and is sold without a washer. The zinc plating provides basic corrosion resistance for general indoor fastening applications. At 3/8 inch length measured under the head, this screw suits lightweight panel assembly, electrical enclosures, and equipment mounting tasks. It is commonly installed by electricians, HVAC technicians, and general maintenance trades when securing sheet metal panels, junction boxes, control boards, and similar hardware.

This screw is suited for residential and light commercial applications where a standard 6-32 UNC thread pattern is required. Typical uses include fastening control panel covers, electrical junction box hardware, and equipment enclosures. The round head profile provides a low-clearance bearing surface and the Phillips drive allows installation with common hand tools or a power driver. Minimum order quantity is 50 pieces per order.

Key Features

• 6-32 UNC thread for wide compatibility with standard tapped holes and nuts
• Round head profile provides broad bearing surface without countersinking
• Phillips drive compatible with standard hand screwdrivers and power drivers
• Grade 2 steel construction for general-purpose fastening strength
• Zinc-plated finish for basic corrosion resistance in dry indoor environments
• No washer included — length measurement taken under the head at 3/8 inch

Compatibility

Designed as a standard 6-32 UNC machine screw for use in any application requiring a round head Phillips fastener with that thread specification.

Installation Notes

Installation requires a Phillips screwdriver or bit sized for a No. 6 fastener. Ensure the receiving hole is properly tapped to 6-32 UNC before driving. Do not overtighten Grade 2 steel screws in thin sheet metal, as stripping is possible. Power down all electrical equipment before fastening or removing hardware on live panels or enclosures.