Value Collection 36717 Sae Flat Washer 5/8 Inch Steel

Product Description

The VALUE COLLECTION 36717 is an SAE flat washer designed for use with 5/8 inch screws and fasteners. Manufactured from Grade 8 steel with a zinc yellow dichromate finish, this washer distributes load across bolted assemblies and helps protect mating surfaces from damage and corrosion. The dichromate finish adds a layer of corrosion resistance suitable for a range of service environments. With an inside diameter of 21/32 inches, an outside diameter of 1-5/16 inches, and a thickness of 3/32 inches, the 36717 meets standard SAE dimensional requirements for this screw size. It is installed by electricians, plumbers, HVAC technicians, and general contractors as part of mechanical assemblies and structural fastening applications.

This SAE flat washer is appropriate for residential and light commercial construction, mechanical equipment mounting, pipe and conduit support hardware, and general trade fastening where a 5/8 inch bolt or screw is used. The SAE specification reflects a larger outer diameter relative to the screw size compared to standard USS variants, making it suitable where broader load distribution is needed across softer or thinner base materials.

Key Features

• Grade 8 steel construction for high-strength fastening applications
• Zinc yellow dichromate finish provides corrosion resistance
• SAE dimensional standard with 21/32 inch ID and 1-5/16 inch OD
• 3/32 inch thickness consistent with SAE flat washer spec for 5/8 inch screw size
• Inch measurement system for compatibility with standard US fastener hardware

Compatibility

Designed as an SAE-standard flat washer for use with 5/8 inch screws and bolts in mechanical, structural, and trade fastening assemblies.

Installation Notes

Install using standard hand or power tools appropriate for the fastener type. Ensure the washer seats flat against the mating surface before torquing the fastener. Inspect the finish for damage before installation in corrosive or wet environments. Follow applicable mechanical or structural codes for the specific application.