Value Collection 36676 Threaded Rod 5/16-18 3 Ft Steel

Product Description

The VALUE COLLECTION 36676 is a fully threaded rod in 5/16-18 thread size, cut to a 3-foot overall length. It is manufactured from low-carbon steel with a yellow zinc finish for basic corrosion resistance. The thread form is Unified National Coarse (UNC) with a right-hand thread direction. This type of threaded rod is a standard fastening component used across mechanical, structural, and trade installations. Plumbers, pipefitters, electricians, and general contractors install threaded rod to hang pipe, conduit, duct, and equipment from overhead structures or to anchor fixtures to framing.

This rod is suited for light- to medium-duty hanging and fastening applications in residential and commercial construction. Common uses include pipe hanger assemblies, conduit support runs, unistrut or channel-rail mounting systems, and general mechanical fastening where a continuous length of UNC-threaded stock is required. The 3-foot length allows field cutting to multiple shorter lengths as the job demands.

Key Features

• 5/16-18 UNC thread form for broad compatibility with standard nuts, couplers, and hardware
• 3-foot overall length — can be cut to shorter lengths in the field
• Low-carbon steel construction for adequate strength in light- to medium-duty fastening
• Yellow zinc finish provides basic corrosion resistance in dry and mildly humid environments
• Right-hand thread direction matches standard fastening hardware without special tooling

Compatibility

Designed for use with standard 5/16-18 UNC hex nuts, coupling nuts, washers, and threaded rod hangers. Fits common pipe hanger and conduit support hardware that accepts 5/16-18 threaded rod.

Installation Notes

Threaded rod installation is performed by plumbers, pipefitters, and electricians depending on the application, and must comply with applicable mechanical and building codes for the trade involved. The rod may be cut to length using a hacksaw or reciprocating saw — deburr cut ends before threading on hardware to avoid cross-threading. Verify that anchor points, beam clamps, or inserts are rated for the intended load before hanging any system weight from the rod. Always follow OSHA and applicable local code requirements for overhead support installations.