Value Collection 36111 Seamless Stainless Steel Tube 5/16 in Od

Product Description

The VALUE COLLECTION 36111 is a seamless 304 stainless steel tube intended for fluid and gas transfer applications where corrosion resistance and dimensional consistency are required. It measures 5/16 inch outside diameter with a 0.065 inch wall thickness, yielding an inside diameter of 0.183 inch. At 6 feet in length and 0.2 pounds, it is easy to handle and cut to final size on the job. Seamless construction eliminates weld seams, reducing potential leak paths and maintaining uniform wall thickness along the full run. Licensed plumbers, HVAC technicians, and mechanical contractors install tubing of this type in refrigeration lines, instrument tubing, and hydraulic or pneumatic pilot lines.

This tube is suited for residential and light commercial applications where a compact-diameter, corrosion-resistant line is needed. Typical uses include instrument sensing lines, control tubing in HVAC and refrigeration equipment, compressed-air pilot lines, and chemical transfer runs in corrosive environments. The 304 stainless steel alloy resists oxidation, moisture, and mild acids, making it a common choice in mechanical rooms, rooftop units, and process areas. At 6 feet, a single length often covers short point-to-point runs without a coupling.

Key Features

• Seamless construction for uniform wall thickness and no weld-seam leak points
• 304 stainless steel alloy provides corrosion resistance in wet and mildly corrosive environments
• 5/16 inch OD with 0.065 inch wall thickness suits tight-clearance instrument and control runs
• 0.183 inch inside diameter supports adequate flow in low-volume fluid and gas lines
• 6-foot length allows single-piece runs for most short installations
• Lightweight at 0.2 pounds for easy handling and field cutting

Compatibility

Designed as an OEM-style replacement or general-use seamless stainless steel tube for instrument, control, and fluid-transfer applications requiring a 5/16 inch OD, 304-grade stainless tube with 0.065 inch wall thickness.

Installation Notes

A licensed plumber or mechanical contractor should perform all tubing installations involving pressurized systems. Shut off and depressurize the system before cutting, fitting, or connecting any tubing. Use a tube cutter rated for stainless steel to achieve a clean, square end; deburr the cut end before inserting into compression or flare fittings. Consult applicable codes such as the IPC or IFGC for pressure ratings, support spacing, and connection requirements specific to the fluid or gas being conveyed.