Value Collection 34768 No.12 Flat Head Phillips Sheet Metal Screw

Product Description

The VALUE COLLECTION 34768 is a No. 12 flat head Phillips sheet metal screw designed for fastening thin-gauge metal panels, ductwork, electrical enclosures, and similar sheet metal assemblies. At 1.5 inches overall length, it is built from Grade 2 steel with a zinc finish that provides basic corrosion resistance in standard indoor applications. The flat head profile sits flush with the material surface after installation, and the Phillips drive is compatible with standard power drivers and manual screwdrivers. This screw uses a Type A and Type AB point, which allows it to self-tap into pre-punched or drilled holes in sheet metal without requiring a separate nut. Sold in a pack of 50 units.

This fastener is a standard trade-supply item used in HVAC duct assembly, electrical panel work, light-gauge metal framing, and general sheet metal fabrication. HVAC technicians commonly use No. 12 screws for connecting duct sections, securing access panels, and attaching equipment covers. Electricians use them for mounting enclosures and junction box covers. The Type A and Type AB point types make them suitable for use in thin sheet metal where thread-cutting on insertion is required.

Key Features

• No. 12 thread size for secure grip in light-gauge sheet metal
• 1.5 inches overall length suits standard duct and panel fastening tasks
• Flat head profile provides a flush finish after installation
• Phillips drive works with standard power drivers and hand tools
• Type A and Type AB point for self-tapping into pre-punched sheet metal
• Zinc finish offers corrosion resistance for typical indoor use

Compatibility

Designed as a general-purpose No. 12 flat head Phillips sheet metal screw suitable for standard light-gauge sheet metal applications in HVAC, electrical, and fabrication work.

Installation Notes

Sheet metal screws of this type are installed by HVAC technicians, electricians, and sheet metal fabricators using standard Phillips-head drivers or power drills set to appropriate torque. Ensure the receiving material is properly supported and that a pilot hole or pre-punched opening matches the intended thread engagement. Power down any electrical equipment or HVAC systems before fastening enclosures or panels. Do not overdrive, as doing so can strip the sheet metal and compromise holding strength.