Value Collection 33512 Stainless Steel Single Jack Chain

Product Description

The VALUE COLLECTION 33512 is a stainless steel single jack chain sold in 1-foot increments from a 100-foot coil. With a wire diameter of 0.08 inches and an inside link length of 0.63 inches, this chain delivers 19 links per foot and carries a working load limit of 16 pounds. The stainless steel construction resists corrosion, making it suitable for wet, humid, or outdoor environments where carbon steel would degrade. This chain is not rated for lifting applications. It is commonly installed by HVAC technicians, plumbers, electricians, and general tradespeople for hanging, suspending, or securing lightweight components and equipment.

Single jack chain in this diameter range sees widespread use in trade and light industrial applications including hanging fluorescent light fixtures, suspending HVAC diffusers and dampers, securing pool equipment covers, supporting plumbing access panels, and similar low-load suspension tasks. The 19-links-per-foot pitch provides frequent attachment points along the run, allowing precise length adjustment during installation. This product is priced and sold by the foot with a minimum order quantity of 50 feet, making it practical for stocking on a service van or in a shop for cut-to-length use.

Key Features

• Stainless steel construction resists rust and corrosion in wet or outdoor environments
• 0.08-inch wire diameter with 0.63-inch inside link length
• 19 links per foot for frequent, precise attachment-point spacing
• 16-pound working load limit suitable for lightweight suspension tasks
• Not rated for lifting — appropriate for hanging and securing applications only
• Sold in 1-foot increments from a 100-foot coil; minimum order quantity of 50 feet

Compatibility

Designed as a general-purpose single jack chain for lightweight suspension and securing applications across HVAC, plumbing, electrical, and pool service trades.

Installation Notes

This chain is not rated for overhead lifting and must not be used in rigging or hoist applications. Cut to required length using bolt cutters or chain cutters appropriate for the wire diameter. Ensure all attachment hardware — hooks, S-hooks, or fasteners — is rated at or above the 16-pound working load limit of this chain. No special licensing is required for installation, but follow applicable local codes when securing mechanical or electrical equipment.