Value Collection 32136 Oval Head Phillips Sheet Metal Screw

Product Description

The VALUE COLLECTION 32136 is a number 8 oval head Phillips drive sheet metal screw intended for fastening thin-gauge metal panels, ductwork, electrical enclosures, and similar sheet metal assemblies. Each screw measures 1 inch in overall length and is manufactured from Grade 2 steel with a zinc-plated finish for basic corrosion resistance. The oval head profile sits slightly above the surface, combining a low-profile look with a wider bearing area than a flat head. The Phillips drive is compatible with standard power drivers and manual screwdrivers common to HVAC, electrical, and light fabrication work. This package contains 50 screws.

These screws are suited for residential and light commercial applications where technicians need a reliable fastener for sheet metal work. Typical uses include securing HVAC duct sections, junction box covers, equipment panels, and sheet metal brackets. The zinc-plated finish provides adequate protection in dry indoor environments. Tradespeople in HVAC, electrical, and general sheet metal trades will find this pack practical for both service calls and installation work.

Key Features

• Number 8 thread size for standard sheet metal fastening applications
• 1 inch overall length suitable for single or double-layer sheet metal
• Oval head profile provides low-profile seating with a wider bearing surface
• Phillips drive compatible with common power and manual drivers
• Grade 2 steel construction with zinc-plated finish for corrosion resistance in dry environments
• Pack of 50 screws for stocking service vans or job site use

Compatibility

Designed as a general-purpose sheet metal screw for use with standard-gauge sheet metal panels, ductwork, enclosures, and brackets in residential and light commercial applications.

Installation Notes

Sheet metal screws should be installed by qualified HVAC technicians, electricians, or sheet metal workers following applicable codes such as the NEC or SMACNA guidelines where relevant. Power down or de-energize any equipment before fastening panels or enclosures. Use a Phillips bit sized to the driver recess to avoid cam-out and strip damage. Do not overtighten, as sheet metal threads can strip if torque is excessive.