Value Collection 320160 Live Center MT2 Taper Shank

Product Description

The VALUE COLLECTION 320160 is a live center designed for use in lathe tailstocks, supporting rotating workpieces during turning operations. It features a Morse Taper 2 (MT2) shank and a long-point tip with a 60-degree included angle, making it well suited for center drilling and turning applications that demand a rigid, low-runout support point. The unit is rated to a maximum workpiece weight of 594 pounds and a maximum spindle speed of 6,400 RPM. With an overall length of 5.059 inches and a head diameter of 1.417 inches, this live center fits standard MT2 tailstock bores found across a wide range of manual lathes. Installed by machinists and tool-and-die professionals, it is a straightforward replacement or shop-spare addition.

This live center is appropriate for general-purpose turning on manual engine lathes in job shop, maintenance, and production environments. The long-point geometry provides access in tighter workpiece geometries compared to standard-point centers. It is suited for both light finishing passes and heavier roughing operations within its rated load and RPM limits. The MT2 taper shank seats directly into compatible tailstock quills without adapters, keeping setup simple and runout minimal.

Key Features

• MT2 Morse Taper shank for direct seating in compatible tailstock bores
• Long-point style tip with 60-degree included angle for improved access in confined workpiece geometries
• 594-pound load capacity supports a broad range of workpiece sizes
• 6,400 RPM maximum speed rating for both finishing and moderate roughing operations
• 0.005 mm accuracy rating for consistent, low-runout center support
• Steel construction throughout for durability under continuous shop use

Compatibility

Designed as a direct-fit replacement for manual lathe tailstocks with a Morse Taper 2 (MT2) bore.

Installation Notes

Installation is performed by machinists or qualified machine tool operators. Before seating the center, power down and lock out the lathe in accordance with applicable lockout/tagout (LOTO) procedures. Clean the tailstock quill bore and the MT2 shank thoroughly to remove chips and oil before insertion, as contamination will affect seating and runout. Do not use impact tools to drive the center into the quill; hand pressure or a soft mallet against the shank flat is sufficient.