Value Collection 32000556 Aluminum Round Rod 6061-T6

Product Description

The VALUE COLLECTION 32000556 is a 2-foot aluminum round rod machined from 6061-T6 alloy stock. This is a solid, extruded rod intended for general fabrication, structural supports, brackets, shafts, and repair work across HVAC, plumbing, electrical, and general mechanical trades. The 6061-T6 temper designation indicates the alloy has been solution heat-treated and artificially aged, resulting in improved tensile strength, machinability, and corrosion resistance compared to softer aluminum grades. At approximately 1.01 pounds, this rod is lightweight and easy to cut, drill, tap, or mill to length on the job or in a shop setting.

This aluminum round rod suits residential and commercial applications where a lightweight, corrosion-resistant material is required. Common uses include custom fabrication of mounting hardware, standoffs, tie rods, and support structures in mechanical and electrical installations. Tradespersons working in corrosive or outdoor environments often specify 6061-T6 aluminum because it holds up well without additional coating. The 24-inch length with a plus-or-minus 0.25-inch length tolerance makes it suitable for most standard rough-cut fabrication tasks before final machining or fitting.

Key Features

• 6061-T6 alloy: heat-treated for improved strength and machinability over annealed aluminum grades
• 24-inch length with a length tolerance of plus or minus 0.25 inches
• Lightweight at approximately 1.01 pounds, easy to handle and transport on service calls
• Solid round rod profile suitable for turning, milling, drilling, and tapping
• Corrosion-resistant aluminum material appropriate for indoor and outdoor mechanical applications

Compatibility

Designed as a general-purpose 6061-T6 aluminum round rod for fabrication and replacement applications across HVAC, plumbing, electrical, and mechanical trades where a 2-foot aluminum round rod stock is specified.

Installation Notes

Cutting and machining should be performed by qualified tradespeople using appropriate tooling for non-ferrous metals. Power down all equipment before replacing or installing fabricated components made from this rod stock. Deburr all cut ends before installation to prevent injury and ensure proper fit. Follow applicable mechanical codes and job-site safety procedures when fabricating structural or load-bearing components.