Value Collection 315-2230 Round Adjustable Pipe Die 1/4-18 Nps

Product Description

The VALUE COLLECTION 315-2230 is a round adjustable pipe die designed to cut 1/4-18 NPS right-hand threads on pipe and fittings. Constructed from high-speed steel, this die maintains cutting edge hardness under the heat and friction generated during threading operations. The adjustable design allows the technician to fine-tune thread fit by expanding or compressing the die within its holder, compensating for tool wear or achieving a tighter thread tolerance. At 2 inches in outside diameter, it fits standard round die stocks sized for 2-inch OD dies. It is used by plumbers, pipefitters, and mechanical tradespeople threading pipe for water, gas, and general service applications.

This die is suited for threading 1/4-inch nominal pipe in residential and light commercial plumbing, gas line, and mechanical piping systems where NPS threads are required. It cuts right-hand threads per NPS standards, making it appropriate for joining to standard fittings, valves, and couplings. The 2-inch OD fits commonly available round die stocks, so it integrates into a typical shop or field threading setup without requiring a specialty holder.

Key Features

• 1/4-18 NPS thread specification for standard pipe threading applications
• High-speed steel construction for durability and heat resistance during cutting
• Adjustable die body allows thread fit fine-tuning and compensation for wear
• 2-inch outside diameter fits standard round die stocks
• Right-hand thread direction per NPS standard

Compatibility

Designed for use in standard 2-inch OD round die stocks. Cuts 1/4-18 NPS right-hand threads on pipe used in plumbing and general mechanical piping applications.

Installation Notes

A licensed plumber or pipefitter should perform pipe threading in systems governed by the IPC or IFGC. Secure the workpiece firmly in a pipe vise before threading and apply cutting oil throughout the operation to extend die life and produce a clean thread. Inspect the die for wear or chipping before each use. After threading, remove chips and verify thread gauge before assembly.