Value Collection 22384 Masonry Drill Bit Set 5 Pc

Product Description

The VALUE COLLECTION 22384 is a 5-piece carbide-tipped masonry drill bit set designed for heavy-duty drilling into concrete, block, brick, and similar masonry substrates. Each bit features a 130-degree point angle optimized for aggressive entry into hard materials, with an oxide finish that provides basic surface protection. The set covers a range from 3/16 inch to 1/2 inch and includes both straight and reduced shank profiles, making the bits compatible with standard drill chucks across that size range. This set is appropriate for contractors, electricians, plumbers, and HVAC technicians who routinely drill masonry penetrations on job sites.

This set is suited for residential and light commercial applications where masonry penetrations are required — anchor bolt holes, conduit pass-throughs, pipe sleeve openings, and similar trade work. The included bits are masonry-specific and are not intended for wood or metal drilling. The case or storage unit keeps the set organized for tool bag or van storage between uses. With five bits spanning the 3/16 to 1/2 inch range, the set covers the most common hole sizes needed for trade anchor and sleeve work.

Key Features

• Carbide-tipped cutting edges for extended service life in masonry materials
• 130-degree heavy-duty point angle for aggressive, centered entry
• Oxide finish provides basic corrosion and wear resistance
• Includes both straight shank and reduced shank profiles for chuck compatibility
• 5-piece set covering 3/16 inch through 1/2 inch diameter range
• Stored in a metal or plastic case for organized transport and storage

Compatibility

Designed as a general-purpose masonry drill bit set for use with standard keyed or keyless drill chucks accepting straight and reduced shank bits in the 3/16 to 1/2 inch size range.

Installation Notes

Masonry drill bits should be used with a hammer drill when drilling into concrete or hard block for best results and to reduce bit wear. Ensure the drill is set to hammer mode and that the work area is clear of embedded conduit, rebar, or pipe before drilling. Eye protection and dust control measures should be followed per applicable jobsite safety requirements. Do not use these bits on wood, metal, or composite materials.