Value Collection 220747 Plasma Cutter Shield Cap 30-130A

Product Description

The VALUE COLLECTION 220747 is a replacement shield cap designed for plasma cutter torch assemblies operating in the 30 to 130 amp range. Shield caps protect the nozzle and electrode from spatter and heat during the cutting arc, extending consumable life and maintaining cut quality. This part is sold individually and suits a wide range of plasma cutting torch configurations where a standard shield cap is required. HVAC fabricators, metal workers, and maintenance technicians who run plasma cutting equipment regularly will recognize this as a routine consumable replacement.

This shield cap is suited for plasma cutting torches rated from 30 to 130 amps, covering light sheet metal work up through heavier structural cutting applications. It is commonly used in shop fabrication, field HVAC ductwork cutting, and general metal processing environments where torch consumables are replaced on a scheduled or as-needed basis. Sold as a single unit, it allows technicians to stock and replace only the components needed without purchasing a full consumable kit.

Key Features

• Compatible with plasma cutting torches rated 30 to 130 amps
• Functions as a direct replacement shield cap to protect nozzle and electrode
• Sold individually for targeted consumable replacement
• Lightweight at 0.2 pounds for easy handling and stocking
• Designed to reduce spatter accumulation and maintain arc stability

Compatibility

Designed as a replacement shield cap for plasma cutting torches operating in the 30 to 130 amp range. Verify torch model and consumable series against manufacturer documentation before ordering to confirm fitment.

Installation Notes

Shield cap replacement is performed by qualified welding or fabrication technicians. Always power down and disconnect the plasma cutter from its power source before replacing torch consumables. Hand-tighten the shield cap to manufacturer specification — do not use tools that could cross-thread or over-torque the cap. Inspect the nozzle and electrode for wear at each shield cap change and replace as a set when signs of erosion are present.