Value Collection 191-232HC Brass Stop Valve 125 Psi Chrome

Product Description

The VALUE COLLECTION 191-232HC is a straight-body brass water supply stop valve designed to control flow at individual fixture supply points. The valve features a 1/2 inch FIP inlet and a 3/8 inch compression outlet, making it a standard configuration for residential and light commercial plumbing rough-in. The brass body carries a chrome finish with a matching chrome handle. Maximum working pressure is rated at 125 psi. This valve is installed by licensed plumbers and experienced plumbing contractors during fixture installation or supply line service work.

This stop valve is suited for any water supply shutoff application, including under-sink installations for faucets, toilets, dishwashers, and similar fixtures. The straight configuration is appropriate where the supply stub-out and fixture supply line are in direct alignment. The 1/2 inch FIP inlet connects to a standard threaded male supply stub-out, and the 3/8 inch compression outlet accepts standard compression-fit supply lines.

Key Features

• Brass body construction for corrosion resistance in potable water service
• Chrome finish on body and handle for a clean, finished appearance
• 1/2 inch FIP inlet for connection to threaded male stub-out
• 3/8 inch compression outlet for standard flexible supply lines
• Rated to 125 psi maximum working pressure
• Straight valve body for in-line supply shutoff configurations

Compatibility

Designed as a standard-configuration replacement or new-installation stop valve for any water supply shutoff application using a 1/2 inch FIP inlet and 3/8 inch compression outlet.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and the IPC. Shut off the main water supply and relieve line pressure before removing any existing valve or making new connections. Use appropriate thread sealant or PTFE tape on the FIP threaded connection and ensure compression fittings are seated and tightened properly without overtightening. Do not exceed the 125 psi rated working pressure.