Value Collection 15296 Pvc 90 Degree Elbow 3/4 Inch

Product Description

The VALUE COLLECTION 15296 is a 3/4-inch PVC 90-degree elbow fitting used to change flow direction in low-pressure plastic piping systems. Made from PVC, this elbow uses slip x slip end connections on both sides, accepting solvent-welded joints for a secure, leak-resistant bond. It is a standard component in residential and light commercial plumbing, irrigation, and pool or spa distribution lines. Plumbers, irrigation technicians, and pool service professionals install this fitting as part of new construction runs or repair work. Its lightweight construction and straightforward solvent-weld installation make it a go-to component for PVC pipe networks.

This elbow is suited for 3/4-inch Schedule 40-style PVC piping applications in water supply distribution, irrigation manifolds, pool equipment plumbing, and general fluid handling systems. The slip x slip connection style requires PVC primer and solvent cement for proper joint assembly. It is appropriate for cold and ambient-temperature water service in both above-ground and in-wall installations where PVC is an approved material per local plumbing code.

Key Features

• 90-degree elbow geometry for right-angle direction changes in PVC pipe runs
• 3/4-inch fitting size for standard 3/4-inch PVC pipe
• Slip x slip end connections on both ends for solvent-weld assembly
• PVC construction provides corrosion resistance and chemical compatibility with water service
• Lightweight design simplifies handling and installation in tight spaces

Compatibility

Designed as an OEM-style replacement or new-installation fitting for standard 3/4-inch PVC piping systems in residential and light commercial plumbing, irrigation, and pool applications.

Installation Notes

Installation is performed by licensed plumbers or qualified irrigation and pool technicians following applicable IPC or local plumbing code requirements. Before cutting into an existing line, shut off the water supply and relieve system pressure. Both the pipe end and the fitting socket must be cleaned, primed, and coated with solvent cement before joining. Allow full cure time per the cement manufacturer instructions before restoring flow.