Value Collection 15007000 Galvanized Round Duct Elbow 7in

Product Description

The VALUE COLLECTION 15007000 is a galvanized steel round adjustable elbow designed for use in sheet metal duct systems. This fitting allows installers to change airflow direction within a ducted HVAC distribution system while maintaining a consistent 7 inch inside diameter throughout the connection. The galvanized steel construction resists corrosion in typical attic, basement, and crawlspace environments. HVAC technicians and sheet metal contractors use this type of elbow during new construction duct runs, renovation work, and duct repair where a fixed elbow angle is not suitable and field-adjustable positioning is required.

This adjustable elbow is suited for residential and light commercial forced-air HVAC duct systems. It is used at directional transitions where rigid elbows would require precise angle cuts. The 7 inch inside diameter makes it appropriate for larger branch runs or main trunk transitions in systems that require higher airflow capacity. It installs without specialized tools and is compatible with standard round duct and fittings of the same inside diameter.

Key Features

• 7 inch inside diameter matches standard round duct sizing for consistent airflow transitions
• Galvanized steel construction provides corrosion resistance for long-term service in unconditioned spaces
• Adjustable design allows field positioning of airflow direction without cutting fixed angles
• Standard gauge sheet metal construction meets typical residential and light commercial duct fabrication requirements
• Sold individually for single-fitting replacement or spot installations

Compatibility

Designed as an OEM-style replacement and new-installation fitting for round galvanized duct systems with a 7 inch inside diameter, consistent with standard residential and light commercial forced-air HVAC ductwork.

Installation Notes

Installation is typically performed by licensed HVAC technicians or sheet metal contractors following local mechanical codes and SMACNA duct construction standards. Power down the air handling unit and verify airflow has stopped before working on any duct section. Secure the elbow to adjoining duct with sheet metal screws and seal all joints with UL 181-rated duct mastic or metal foil tape to maintain system static pressure. Do not use standard cloth duct tape as a permanent sealant on metal duct joints.