Value Collection 15003006 Galvanized Round Adjustable Elbow

Product Description

The VALUE COLLECTION 15003006 is a galvanized steel round adjustable elbow designed for use in low-pressure HVAC ductwork systems. Fabricated from 26-gauge galvanized steel, this fitting features a 3-inch inside diameter and allows the installer to set the bend angle to route ductwork around obstructions without cutting additional pieces. The 6.5-inch overall width accommodates standard residential and light commercial trunk-and-branch layouts. HVAC technicians and sheet metal installers use this type of fitting to complete supply and return air distribution runs in forced-air systems.

This adjustable elbow is suited for residential and light commercial forced-air duct systems where round galvanized fittings are required. It is commonly installed in attic, crawlspace, and mechanical room ductwork runs where directional changes are needed. The 3-inch end size matches standard 3-inch round duct collars, flexible duct connections, and register boots used in branch-run installations. One fitting is included per package.

Key Features

• 26-gauge galvanized steel construction resists corrosion in typical attic and crawlspace environments
• Adjustable elbow design allows variable bend angle to suit field conditions without cutting additional fittings
• 3-inch inside diameter fits standard round duct and flexible duct branch connections
• 6.5-inch overall width accommodates typical residential branch-run spacing
• Lightweight at 0.48 pounds, reducing handling fatigue on overhead installations

Compatibility

Designed as an OEM-style replacement and new-installation fitting for 3-inch round galvanized ductwork systems in residential and light commercial forced-air HVAC applications.

Installation Notes

Installation is typically performed by a licensed HVAC technician or sheet metal installer in accordance with SMACNA duct construction standards and local mechanical codes. Power down the air handling unit and shut off the system at the disconnect before working in the duct system. Secure the fitting with sheet metal screws and seal all joints with listed duct mastic or foil-backed tape per energy code requirements. Do not use standard cloth-backed duct tape as a primary seal.