Value Collection 1426 Nylon Push Mount Automotive Rivet

Product Description

The VALUE COLLECTION 1426 is a nylon push mount rivet designed for automotive body and trim fastening applications. This clip-style fastener installs without tools by pressing directly into a pre-drilled or factory hole, creating a secure, vibration-resistant hold. Molded from nylon, it resists corrosion and will not scratch surrounding panels or liners. It is commonly installed by automotive technicians, body shop professionals, and experienced DIYers performing trim restoration or panel replacement work. The lightweight construction keeps overall assembly weight low while maintaining adequate holding strength for non-structural trim retention.

This rivet is suited for use on rocker panels, wheel well liners, and air inlet trim pieces on passenger vehicles and light trucks. It is a direct push mount style, meaning it seats flush or near-flush against the panel surface once fully seated. Typical applications include re-securing loose wheel arch liners after under-vehicle service, reattaching air inlet trim that has lost its original fasteners, and replacing damaged factory push clips during body panel removal and reinstallation procedures.

Key Features

• Nylon construction resists corrosion and will not damage surrounding panel surfaces
• Push mount installation requires no tools — seats by hand pressure into a pre-drilled or factory opening
• Suitable for rocker panels, wheel liners, and air inlet trim retention
• Lightweight at 0.01 pounds per unit, adding negligible mass to trim assemblies
• Minimum order quantity of 25 units supports fleet service and shop stocking needs

Compatibility

Designed as a push mount trim fastener for general automotive rocker panel, wheel liner, and air inlet applications. Verify hole diameter and clip head dimensions against vehicle-specific fastener specifications before installation.

Installation Notes

Installation is performed by automotive technicians or body shop professionals. Confirm the mounting hole is clean and free of debris before seating the rivet. Align the rivet shank with the hole and apply firm, even hand pressure until the clip fully seats. When removing existing push mount rivets, use a trim removal tool to avoid cracking the nylon body or damaging surrounding panel material.