Value Collection 13077G Malleable Iron Reducing Coupling

Product Description

The VALUE COLLECTION 13077G is a malleable iron reducing coupling designed to connect pipes of two different diameters in threaded piping systems. This Class 150 fitting transitions from a 2-inch nominal pipe to a 1-inch nominal pipe and is rated for 300 psi on liquid and gas service and 150 psi on steam service. Malleable iron construction provides the ductility and impact resistance needed in mechanical, plumbing, and industrial piping runs. Licensed plumbers, pipefitters, and HVAC-R mechanics install this type of fitting in both new construction and retrofit work.

This reducing coupling is suitable for residential and light commercial piping systems carrying water, air, natural gas, propane, steam, and compatible liquids. It is commonly installed in supply and return lines, gas distribution manifolds, boiler piping, and compressed air systems where a threaded reduction from 2 inches to 1 inch is required. The Class 150 designation is standard for general-purpose threaded malleable iron fittings in low- to medium-pressure service.

Key Features

• Malleable iron construction provides ductility and resistance to impact and vibration in threaded piping systems
• Rated 300 psi for liquid and gas service
• Rated 150 psi for steam service
• Class 150 designation suits a wide range of residential and commercial applications
• Reduces from 2-inch to 1-inch nominal pipe size in a single threaded fitting

Compatibility

Designed as an OEM-style replacement or new-installation fitting for standard NPT-threaded malleable iron piping systems in Class 150 service.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter following applicable local codes, IFGC requirements for gas service, and ASME B16.3 standards for malleable iron threaded fittings. Shut off and depressurize the line completely before removing or installing any threaded fitting. Apply an appropriate thread sealant or PTFE tape to the male threads before assembly. Do not over-torque; hand-tighten and use a pipe wrench for final engagement only.