Value Collection 13010 Malleable Iron 45 Elbow 1/8 Inch

Product Description

The VALUE COLLECTION 13010 is a malleable iron 45-degree elbow pipe fitting designed for threaded piping systems in plumbing, gas distribution, and industrial pipe runs. Sized at 1/8 inch, it is rated for 300 psi on liquid and gas service and 150 psi on steam service. The fitting carries a Class 150 designation and ships with a galvanized finish coating that resists corrosion in exposed or mildly harsh environments. Licensed plumbers and pipefitters install this type of fitting when a 45-degree directional change is required in a small-diameter threaded line.

This fitting is suited for residential and light commercial plumbing and gas piping applications where 1/8-inch NPT threaded connections are specified. Typical uses include low-pressure gas supply branches, compressed air distribution, water supply connections, and steam systems operating within the rated pressure limits. The galvanized finish makes it appropriate for installations where bare iron would be undesirable. The 1/8-inch size is commonly found at instrument ports, pilot gas lines, and small-diameter service taps. Each package contains 5 fittings.

Key Features

• 300 psi liquid and gas pressure rating for reliable service in pressurized piping
• 150 psi steam pressure rating for low-pressure steam applications
• Class 150 malleable iron construction for ductility and impact resistance versus cast iron
• Galvanized finish coating for added corrosion resistance
• 45-degree elbow geometry for directional changes in tight piping layouts
• 1/8-inch fitting size for small-diameter threaded connections

Compatibility

Designed as an OEM-style replacement or new-installation fitting for 1/8-inch NPT threaded piping systems in plumbing, gas, and steam service applications.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable local codes, the International Plumbing Code, or the International Fuel Gas Code. Isolate and depressurize the line completely before disassembly or installation of any threaded fitting. Apply an appropriate thread sealant or PTFE tape to the male threads before assembly, and tighten to snug-plus-hand-tight without over-torquing malleable iron threads. Pressure-test the assembly per job-site requirements before returning the system to service.