Value Collection 1172MPR 10-32 X 4-1/2 in Round Head Phillips Screw

Product Description

The VALUE COLLECTION 1172MPR is a 10-32 machine screw with a round head and Phillips drive, manufactured from steel with a zinc finish. Measuring 4-1/2 inches in length under head, this fastener meets ASME B18.6.3 and SAE J82 standards for dimensional and mechanical compliance. The zinc coating provides basic corrosion resistance for general indoor and light-duty applications. It ships in a package quantity of one unit with a minimum order quantity of ten. Electricians, HVAC technicians, panel builders, and general trade professionals routinely use this screw size when securing components, brackets, and enclosures in standard inch-measurement assemblies.

This 10-32 Phillips round head machine screw is appropriate for residential and light commercial applications where a standardized inch-thread fastener is required. Typical uses include securing electrical panels, HVAC equipment covers, junction box hardware, and control board mounting brackets. The round head profile provides a low-profile bearing surface suited for flush or near-flush mounting into tapped holes or with standard hex nuts. No specific model or equipment compatibility is stated by the manufacturer for this fastener.

Key Features

• 10-32 unified fine thread for positive engagement in tapped holes or standard nuts
• 4-1/2 inch length under head accommodates deeper assemblies and stacked components
• Phillips drive works with standard No. 2 Phillips screwdrivers and bits
• Zinc finish provides basic corrosion resistance for general-duty environments
• Meets ASME B18.6.3 and SAE J82 dimensional and mechanical standards
• No washer — suited for direct bearing against tapped material or use with a standard nut

Compatibility

Designed as a standard 10-32 inch-thread machine screw compatible with any application requiring ASME B18.6.3 or SAE J82 compliant fasteners with a round head Phillips drive configuration.

Installation Notes

This fastener is installed by electricians, HVAC technicians, and mechanical contractors using standard No. 2 Phillips screwdrivers or power drivers with a No. 2 Phillips bit. De-energize all electrical equipment and follow applicable NEC or equipment manufacturer lockout-tagout procedures before accessing panels or enclosures where this screw is being installed or replaced. Do not overtighten into tapped plastic housings or thin sheet metal, as the fine thread engagement is limited in soft materials. Confirm thread engagement depth is adequate before applying torque.