Value Collection 114TFMAS1 Masonry Nails 9 Gauge

Product Description

The VALUE COLLECTION 114TFMAS1 is a 9 gauge fluted shank masonry nail designed for fastening into concrete, block, and masonry surfaces. At 1-1/4 inches overall length, this nail is suited for light-duty anchoring tasks where a direct-drive fastener is needed without adhesive or anchor inserts. The fluted shank increases holding power by displacing material as it is driven, improving pull-out resistance in hard substrates. Constructed from Grade 2 steel with an uncoated finish, this nail is intended for dry or protected interior masonry applications. Electricians, HVAC installers, and general contractors commonly use masonry nails for securing conduit clips, strapping, and lightweight brackets to masonry walls.

This nail is typically used in residential and light commercial construction and service work where fastening to concrete block, poured concrete, or brick is required. Common applications include securing furring strips, wire strapping, and conduit anchors to interior masonry surfaces. The 1-1/4 inch length makes it appropriate for thin materials fastened directly to a masonry substrate. It is driven with a hammer and is best suited for use in dry, indoor environments given the uncoated steel finish.

Key Features

• 9 gauge diameter for consistent sizing across masonry fastening applications
• 1-1/4 inch overall length suitable for thin-material-to-masonry fastening
• Fluted shank design increases pull-out resistance in hard substrates
• Grade 2 steel construction provides standard hardness for masonry driving
• Uncoated finish intended for dry, protected interior installations

Compatibility

Designed as an OEM-style replacement fastener for general masonry nail applications in residential and light commercial construction and mechanical trades work.

Installation Notes

Masonry nails are installed by general contractors, electricians, and mechanical trades using a standard hammer or masonry nail set. Always wear appropriate eye protection when driving masonry nails, as material fragments can dislodge during installation. Verify the substrate is structurally sound and free of voids before driving. Do not use uncoated steel fasteners in wet, exterior, or high-humidity environments where corrosion resistance is required.