Value Collection 111CB25060 Pressure Gauge 60 Psi

Product Description

The VALUE COLLECTION 111CB25060 is an analog pressure gauge designed for monitoring system pressure in plumbing, HVAC, and general industrial applications. It features a 2.5-inch dial with a 0 to 60 psi range and an accuracy rating of plus or minus 3-2-3 percent of scale. The case is constructed from ABS (Acrylonitrile Butadiene Styrene), and all wetted parts are brass, including a bronze Bourdon tube. The 1/4-inch NPT center back mount configuration allows direct inline installation on pipes, tanks, and manifolds. This gauge is a dry (non-liquid-filled) unit suitable for use by plumbers, HVAC technicians, and industrial maintenance professionals.

This gauge is well suited for residential and light commercial applications where a compact, readable pressure display is needed. Common install scenarios include boiler systems, water supply lines, compressed air lines, irrigation manifolds, and hydronic heating loops. The center back mount allows the gauge to sit flush against panels or pipe risers for clean, readable placement in tight mechanical spaces.

Key Features

• 0 to 60 psi pressure range with analog dial readout
• 2.5-inch dial diameter for clear, at-a-glance readings
• Plus or minus 3-2-3 percent of scale accuracy (ASME Grade B)
• Brass wetted parts and bronze Bourdon tube for corrosion resistance
• ABS case construction — lightweight and durable
• 1/4-inch NPT center back mount for straightforward inline installation
• Dry gauge — no liquid fill, suitable for non-pulsating service

Compatibility

Designed as a direct-fit replacement or new-installation pressure gauge for systems using 1/4-inch NPT back-mount connections with a 0 to 60 psi service range.

Installation Notes

Installation is typically performed by a licensed plumber or HVAC technician. Shut off system pressure and bleed the line before removing an existing gauge or threading in this unit. Apply thread sealant tape or pipe thread compound to the NPT threads per local code requirements. Do not over-tighten the gauge body — use a wrench on the hex fitting only, not on the case or dial.