Value Collection 1024TSP Steel Thumb Screw 10-24 Oval Head

Product Description

The VALUE COLLECTION 1024TSP is a steel thumb screw with a 10-24 UNC thread and an oval head profile. It is designed for hand-tightened fastening applications where tools are impractical or unnecessary. The screw features a shoulder below the head, providing a controlled bearing surface and lateral support during installation. With a 1.5-inch overall length and uncoated steel construction, it is suited for light mechanical assemblies, panel fastening, and equipment covers. Material Grade 2 steel provides adequate tensile strength for general-duty hand-fastening use. Measured in inch standard, this part is sold individually but requires a minimum order of 10 pieces per order.

This thumb screw is used in applications where frequent manual adjustment, removal, or repositioning is needed without tools. Common installation scenarios include electrical enclosures, instrument panel covers, light-duty fixtures, and mechanical sub-assemblies. The oval head and shoulder configuration makes it a practical choice for applications that benefit from a low-profile clamping surface and positive seating. It is typically installed by electricians, mechanical assemblers, and maintenance technicians working on panel and enclosure hardware.

Key Features

• 10-24 UNC thread standard for broad compatibility with standard tapped holes
• Oval head profile with shoulder provides a stable bearing surface during hand tightening
• 1.5-inch overall length suits medium-depth fastening requirements
• Uncoated steel construction for general-duty indoor mechanical use
• Head diameter of 0.39 inches and head height of 0.49 inches for low-profile installation
• Shoulder diameter of 0.33 inches supports lateral alignment during assembly

Compatibility

Designed as a standard 10-24 UNC thumb screw for use in any application requiring a hand-fastened oval head fastener with a shouldered shank in an inch-standard tapped hole.

Installation Notes

Installed by hand; no tools are required for standard use. Ensure the mating tapped hole is clean and free of debris before threading to avoid cross-threading the uncoated steel. Do not exceed hand-tight torque, as over-tightening can strip the 10-24 thread in softer base materials. Confirm shoulder diameter clearance in the through-hole before installation.